DIY Zip Tee
I love sewing and wearing basics with a twist. For example, a t-shirt that has an extra detail like this Coats & Clark Fashion zipper sewn on the shoulder seam. You can wear it with the zipper open or closed. Either way it adds a bit of edge to your average t-shirt and simple to do. You can add this to a t-shirt or make one. I wanted make a one using a soft, drapey rayon jersey from Stylish Fabric. They have just about every color so have your pick! Get the details below and make your own.
- 2 x Coats & Clark 7" Fashion Aluminum Closed End Zipper
- 1 yd Stylish Fabric Rayon Jersey.
- Coats & Clark All-Purpose Thread
- Sewing pattern or t-shirt (I drafted mine but New Look 6519 is a good option for this and would even be cute on the dress).
- 2" strips of interfacing
- Brother Sewing Machine
Cut out your pattern. For this pattern I drafted mine but you can use any pattern just make sure whatever zipper length you plan to use that the shoulder seam measures this length. For example I'm using a 7" zipper so I made sure the shoulder seams measured this length plus 1/2" for hem allowance on the sleeve.
The material I'm using is a light weight rayon jersey material so I'm adding a 2" strip of interfacing to the shoulder edges. The heavy duty zipper will then sew nicely along the rayon jersey with waving. At this point you will also want to fold over the sleeve openings and hem the edge. I pressed 1/4" and topstitched with a straight stitch.
Place the zipper right sides together along the shoulder edge and pin. Fold the top tape end towards the zipper so the top stop meets the finished edge of your arm opening. The bottom tape end should hang over a bit since you will be sewing binding along the neckline.
Use the zipper foot and sew into place.
Add the back and place right sides together and repeat.
It should now look like this. Repeat for the other shoulder.
Cut a strip of fabric that measures the neckline -3". The width of mine was 1.5". Sew the strip ends together to create a loop. Fold and press the binding in half (right side up). Pin evenly around the neckline with the seam in the center back. As you sew you will need to pull the binding slightly to fit around the neckline opening. Sew with a slight zigzag stitch.
Once sewn, press up. I did serge the seam allowance.
Flip right side together and sew the side seams. Then fold over the bottom hem and sew up. I have already made a couple versions and even a long sleeve one. Hope you give this fun one a try!