Skip to Main Content
You may experience order delays. Learn More
  1. How-To
  2. Beyond Basics
  3. Add Trim with Multi-Hole Foot

Add Trim with Multi-Hole Foot

sewing
Add Trim with Multi-Hole Foot

Whether it comes with your machine, or you purchase it as an accessory, this little foot creates lots of stitching fun!

The multi-hole foot, or multi-cord foot has either holes in the surface or channels under it that allow you to feed multiple strands of specialty threads, small cords, yarns, metallics, ribbons, etc. through them for couching. The foot keeps all the strands parallel for you while you stitch.

Add Trim with Multi-Hole Foot

Courtesy of Pfaff.

Depending on the brand, you may be able to couch over three, five, seven or nine strands at once. Strands can be all the same color, or totally different colors, and you can create a secondary pattern by the sequencing of colors. For example, put darker strands along the outside and lighter ones in the center.

Add Trim with Multi-Hole Foot

Create a pattern with different colors of cord- Courtesy of Husqvarna Viking.

If you thread the machine needle with Coats Polyester Embroidery thread, Coats & Clark Cotton Machine Quilting thread, or even regular Dual Duty XP all-purpose sewing thread in a contrast color, the stitching becomes a prominent part of the couched design. For fun, try a Coats Thread in a multi-color. If you prefer to let the strands show their stuff, then thread the machine with Coats Transparent thread.

A zigzag or almost any open decorative stitch can be used, but be sure the stitch width covers all the strands for maximum hold. On some fabrics it may be necessary to add stabilizer under the stitching to prevent puckering.

Add Trim with Multi-Hole Foot

Courtesy of Husqvarna Viking.

Stitch slowly as you’re guiding multiple strands at one time — either following a design line marked on your fabric or free-form.

If the design line doesn’t end in a seam, thread each strand through to the underside and knot, or extend the ends and tie them into a knot or tassel for additional decoration.

Yarnspirations Tip icon

Tips

If your machine brand has a foot with holes in it, use a wire needle threader to pull each strand through the top of the foot. On machines with channels, simply open the latch to lay in the strands in order, then snap closed for stitching.

Add Trim with Multi-Hole Foot

Foot with Latch Open- Courtesy of Bernina.

Add Trim with Multi-Hole Foot

Courtesy of Pfaff.

Categories