Tasseled Phone Case

Home | Caron | Patterns | Tasseled Phone Case
Share to Facebook Share to Twitter Share to Pinterest Email this page Print this page

Tasseled Phone Case

designed by Caron Design Team
Free Pattern
No votes yet
Rate this pattern

Keep your phone safe from bumps and thumps while turning it into a cute fashion accessory with this tasseled phone case.


Single Size
Case measures approximately 4½"/11cm high and 3½"/9cm wide
Download Pattern

Customize your kit

The materials for this project cost $20.91

Step 1:

Select your options


  • Single Size
Finished measurements
Case measures approximately 4½"/11cm high and 3½"/9cm wide

Step 2:

Click each color to change it or go with the colors recommended by the designer

Contrast A

Simply Soft Party | Fuchsia Sparkle, 0002Edit Color

Contrast B

Simply Soft Party | Black Sparkle, 0007Edit Color

Single Point Aluminum Knitting Needles 14"

Size 9/5.5mm

Bamboo Crochet Hook

Size G6/4mm

Chibi Tapestry Needle Set

Jumbo 2/Pkg

Materials not included in this kit:

Pins. 44 fuchsia seed beads (optional)—Size 8. 22 black tube beads (optional)—Size 8. Beading needle (optional). Beading thread (optional).

The materials for this project cost $20.91


Ch(s) = Chain(s)

sc = single crochet

Sc3tog = Single crochet 3 together—[Insert hook in next stitch, yarn over and draw up a loop] 3 times, yarn over and draw through all 4 loops on hook

Sl st = Slip stitch

Sl1wyif = Slip next stitch knitwise, with yarn in front of work.

WS = wrong side

Details & Instructions


Finished measurements
Case measures approximately 4½"/11cm high and 3½"/9cm wide


Simply Soft Party (85 g/3. oz;150 m/164 yds)
Contrast A Fuchsia Sparkle (0002) 1
Contrast B Black Sparkle (0007) 1
One pair knitting needles size US 8 (5.5mm) or size to obtain gauge. One size US G/6 (4mm) crochet hook, or size to obtain gauge. Yarn needle. Pins. 44 fuchsia seed beads (optional)—Size 8. 22 black tube beads (optional)—Size 8. Beading needle (optional). Beading thread (optional).


In Two-Color Linen Stitch, 18 sts and 30 rows = 4"/10 cm. Gauge is not important for this project.


Two-Color Linen Stitch (multiple of 2 sts + 1)
Row 1 (RS): With B, k1, *sl 1 wyif, k1; repeat from * across.
Row 2: With B, purl.
Row 3: With A, k2, *sl 1 wyif, k1; repeat from * across to last st, k1.
Row 4: With A, purl.
Repeat Rows 1–4 for Two-Color Linen Stitch.
Carry color not in use up side of piece.
With B, CO 15.
Knit 1 row.
Work in Two-Color Linen Stitch until piece measures 4”/10cm from beginning, ending with a WS row.
With B, knit 2 rows. 
Bind off.
Work same as Front.
With B, ch 15. 
Row 1: Sc in 2nd ch from hook and in each remaining ch across, turn—14 sc. 
Rows 2–6: Ch 1, sc in each sc across, turn. 
Fasten off.
With B, ch 230; taking care not to twist ch, join with sl st in first ch to form a ring.
Round 1: Sl st in each ch around.
Fasten off. 
Hold front and back with WS together, sew sides and lower edges together, leave top edge open.
Wristband: Center wristband on back of case, with short ends aligned with side edges of case. Sew ends of wrist band securely in place.
Strap/Handle: Beginning at top of one side of case, pin strap down the side, across the lower edge, and back up the other side of the case (leaving long, top section of strap unpinned for handle). Sew strap in place around case.
Tasseled Strap
Mark center of top edge of back.
Row 1: Join B with sc 1 st before center, sc in center, sc on other side of center, turn—3 sc.
Rows 2–4: Ch 1, sc in each sc across, turn. 
Row 5: Ch 1, sc3tog—1 st.
Fasten off.
Wrap B around four fingers of one hand, about 20 times. Thread an 8"/20.5cm length of B under top of wraps and tie in a knot, then tie the ends together for hanging cord. Cut lower ends of wraps and remove from fingers. Wrap a 12"/30.5cm length of B around the tassel, about 1"/2.5cm below the top to form tassel neck, and draw ends down through tassel neck to inside of tassel. Note: If beads will not be added, wrap tassel neck 4 times around with B.
beaded tassel neck wrap (optional): Thread beads onto beading thread in the following order: *2 fuchsia, 1 black; repeat from * until all beads are threaded. Cut thread, leaving a 6"/15cm tail. Tie tail around tassel neck, and slide beads down close to tassel. Secure last bead. Wrap beaded thread around neck of tassel and secure.
Attach tassel to end of tassel strap using hanging cord. Using yarn needle, weave in all ends.